Fault Code Nos.
Fault Code No.: 14 Diagnostic Code No.: 03
Note: If Fault Code Nos. "13" and "14" are both indicated, take the actions specified for Fault
Code No. "13", first.
Note: If Fault Code Nos. "13" and "14" are both indicated, take the actions specified for Fault
Code No. "13", first.
Item: Intake air pressure sensor: hose system malfunction (clogged or detached hose).
Fail-Safe System: Able to Start Engine | Able to Drive Vehicle
Indicated: Displays the intake air pressure.
Procedure: Set the engine stop switch to "RUN", and then operate the throttle while pushing the start switch.
(If the display value changes, the performance is OK.)
(If the display value changes, the performance is OK.)
Probable Cause of Confirmation of Service
Item Malfunction and Check Maintenance Job Completion
Item Malfunction and Check Maintenance Job Completion
1
|
Condition of intake air pressure sensor hose.
Check the intake air pressure sensor hose condition. |
Clogged or detached hose.
Repair or replace the sensor hose. |
Start the engine and let it idle
for approximately 5 seconds. If, the Fault Code No. is NOT displayed, then Service is Complete. If however, the Fault Code No. is displayed, then Go To Item 2 below. |
2
|
Defective intake air pressure
sensor. |
Execute the diagnostic
mode. (Code No. 03). When engine is stopped: Atmospheric pressure at the current altitude and weather conditions is indicated. At sea level: Approx. 101 kPa (757.6 mmHg, 29.8 inHg) 1000 m (3300 ft) above sea level: Approx. 90 kPa (675.1 mmHg, 26.6 inHg) 2000 m (6700 ft) above sea level: Approx. 80 kPa (600.0 mmHg, 23.6 inHg) 3000 m (9800 ft) above sea level: Approx. 70 kPa (525.0 mmHg, 20.7 inHg) When engine is cranking: Make sure that the indication value changes. The value does not change when engine is cranking. Check the intake air pressure sensor. Replace if defective. |
© 2013-15 cvvmax. No animals, HDs or Ducatis were harmed in the making of this site.