cvvmax's Garage

Picture
Picture
Picture
Picture
Picture
Picture

Fault Code Nos.
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture

Fault Code No.: 30     Diagnostic Code No.: 08

Item: Latch up detected.

Fail-Safe System: Unable to Start Engine   |   Unable to Drive Vehicle

Indicated: Lean angle sensor output voltage
                 • 0.4-1.4 (upright)
                 • 3.7-4.4 (overturned)

Procedure: Remove the lean angle sensor and incline it more than 45 degrees.

               Probable Cause of                                                       Confirmation of Service
  Item       Malfunction and Check            Maintenance Job              Completion

1
The vehicle has overturned.
Raise the vehicle upright.
Turn the main switch to "ON".

If, the Fault Code No. is NOT displayed, then Service is Complete.


If however, the Fault Code No. is displayed, then Go To Item 2 below.

2
Installed condition of lean
angle sensor.

Check the installed direction and condition of the sensor.
Turn the main switch to "ON".

If, the Fault Code No. is NOT displayed, then Service is Complete.


If however, the Fault Code No. is displayed, then Go To Item 3 below.

3
Defective lean angle sensor.
Execute the diagnostic
mode. (Code No. 08).

An indicated value is out of the specified range.

Replace the lean angle sensor.
Turn the main switch to "ON".
If, the Fault Code No. is NOT displayed, then Service is Complete.


If however, the Fault Code No. is displayed, then Go To Item 4 below.

4
Malfunction in ECU.
Replace the ECU.

Picture
Picture
Picture
Picture
Picture
Picture

© 2013-15 cvvmax. No animals, HDs or Ducatis were harmed in the making of this site.
Proudly powered by Weebly