cvvmax's Garage

Picture
Picture
Picture
Picture
Picture
Picture

Fault Code Nos.
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture
Picture

Fault Code No.: 43     Diagnostic Code No.: 09 and 50

Item: Fuel system voltage: incorrect voltage supplied to the fuel injector and fuel pump.

Fail-Safe System: Able to start engine | Able to Drive Vehicle

Indicated: Fuel system voltage (battery voltage)
                 Approximately 12.0 VDC

Diagnostic Code No.: 09
Procedure: Set the engine stop switch to "o", and then compare the actually measured battery voltage with
                  the display value. (If the actually measured battery voltage is low, recharge the battery.)

Diagnostic Code No.: 50
Actuation: Actuates the relay unit five times at one-second intervals. Illuminates the engine trouble warning
                 light.

Procedure: Check that the relay unit is actuated five times by listening for the operating sound.

               Probable Cause of                                                       Confirmation of Service
  Item       Malfunction and Check            Maintenance Job              Completion

1
Connection of relay unit coupler.

Check the locking condition
of the coupler.

Disconnect the coupler and
check the pins (bent or broken terminals and locking
condition of the pins).
Improperly connected.

Connect the coupler securely or replace the wire harness.
Start the engine and let it idle for approximately 5 seconds.

If the Fault code number is not displayed, the Service is finished.

If however, the Fault code number is displayed, then go to item 2.

2
Connection of ECU coupler.

Check the locking condition
of the coupler.

Disconnect the coupler and
check the pins (bent or broken terminals and locking
condition of the pins).

Improperly connected.

Connect the coupler securely or replace the wire harness.
Start the engine and let it idle for approximately 5 seconds.

If the Fault code number is not displayed, the Service is finished.

If however, the Fault code number is displayed, then go to item 3.

3
Wire harness continuity.
Open or short circuit.

Replace the wire harness.

Between relay unit coupler and ECU coupler.
(Red/Blue-Red/Blue)

Between starter relay coupler and relay unit coupler.
(Red/Black-Red/Black)

Between starter relay coupler and battery.
(Red-Red)

Start the engine and let it idle for approximately 5 seconds.

If the Fault code number is not displayed, the Service is finished.

If however, the Fault code number is displayed, then go to item 4.

4
Defective relay unit.
Execute the diagnostic
mode. (Code No. 50).

If there is No operating sound,  replace the relay unit.

Start the engine and let it idle for approximately 5 seconds.

If the Fault code number is not displayed, the Service is finished.

If however, the Fault code number is displayed, then go to item 5.

5
Defective relay unit.
Execute the diagnostic
mode. (Code No. 09).

If the Fuel system voltage is below 3 VDC, replace the relay unit.
Start the engine and let it idle for approximately 5 seconds.

If the Fault code number is not displayed, the Service is finished.

If however, the Fault code number is displayed, then go to item 6.

6
Malfunction in ECU.
Replace the ECU.

Picture
Picture
Picture
Picture
Picture
Picture

© 2013-15 cvvmax. No animals, HDs or Ducatis were harmed in the making of this site.
Proudly powered by Weebly